PYQ Vault

Homi Bhabha Physics · Current Electricity

Ohm's Law and Resistance

Ohm's law says V = IR at a fixed temperature; a wire's resistance grows with its length and falls as it gets thicker (R = ρl/A), while its resistivity ρ depends only on its material and temperature.

Why this matters

The busiest page of the chapter: nine questions, one EASY, seven MODERATE and one HARD. One uses V = IR on a table of readings. Five compare wires of the same metal by their length and area of cross-section (the same four-piece figure was asked in January 2021 and again in 2024). Three are about resistivity: putting metals in order, what changes it, and the temperature at which resistance almost vanishes.

Concept 1 of 3: Ohm's law: V = IR

Push harder and more water flows through a pipe. In the same way, a bigger potential difference drives a bigger current through a wire. For a metal wire kept at the same temperature, the current goes up in exactly the same proportion: double the voltage, double the current. The fixed ratio of the two is the wire's resistance.

Definition

  • Ohm's law: at a constant temperature, the current through a conductor is directly proportional to the potential difference across it.
  • So VI\frac{V}{I} is a constant, the resistance R: V=IRV = IR.
  • Unit of resistance: the ohm (Ω). 1 Ω is the resistance that lets 1 A flow when 1 V is applied.
  • A graph of V against I for such a conductor is a straight line through the origin.
  • Change milliamperes to amperes first: 1 mA = 0.001 A.

Ohm's law

V=IRI=VRR=VIV = IR \qquad I = \frac{V}{R} \qquad R = \frac{V}{I}
  • VVpotential difference, in volts (V)
  • IIcurrent, in amperes (A)
  • RRresistance, in ohms (Ω)

Worked example

A heater coil draws a current of 4 A from a 220 V supply. Find its resistance. What current would it draw from a 110 V supply?
Practise this conceptself-check · 4 quick reps

The same idea in a real exam question:

Homi Bhabha Class 9 · 2017 · Homi Bhabha Std IX (16 September 2017) · Q17Easy

Example 1 · Current Electricity · Ohm's Law and Resistance

Using Ohm's Law determine the value of 'x' in the following table.
Sr. No.Voltage VCurrent I
1.1 V50 mA
2.x V75 mA

Using milliamperes as amperes

Change mA to A before using V = IR. A current of 100 mA through 30 Ω needs 3 V, not 3000 V.

Thinking the resistance changes with the voltage

For a metal wire at the same temperature, R stays the same. If V doubles, I doubles, and V divided by I is unchanged.

Concept 2 of 3: Length, thickness and resistance: R = ρl/A

Electrons bump into the metal's atoms as they move. A longer wire means more bumps, so more resistance. A thicker wire is like a wider road: more electrons can pass side by side, so less resistance. That is why the resistance goes up with length and down with the area of cross-section.

Definition

  • For one material, resistance is directly proportional to length: R∝lR \propto l.
  • It is inversely proportional to the area of cross-section: R∝1AR \propto \frac{1}{A}.
  • Together: R=ρlAR = \rho\frac{l}{A}, where ρ is the resistivity of the material.
  • To compare pieces of the same metal, just compare lA\frac{l}{A} for each piece.
  • For a round wire A=πr2A = \pi r^2: doubling the radius makes the area 4 times, so the resistance becomes one quarter.
  • Stretching a wire to twice its length also halves its area (the volume stays the same), so its resistance becomes 4 times.

Resistance of a wire

R=ρlAA=πr2R = \rho\frac{l}{A} \qquad A = \pi r^2
  • RRresistance, in ohms (Ω)
  • ρρresistivity of the material, in ohm metre (Ω m)
  • lllength of the wire, in metres
  • AAarea of cross-section, in square metres
  • rrradius of a round wire

Worked example

Wire X has a length of 40 cm and an area of cross-section of 2 mm². Wire Y, of the same metal, has a length of 120 cm and an area of cross-section of 0.5 mm². Find the ratio of the resistance of X to that of Y.
Practise this conceptself-check · 4 quick reps

The same idea in a real exam question:

Homi Bhabha Class 9 · 2024 · Homi Bhabha Std IX (30 November 2024) · Q27Moderate

Example 2 · Current Electricity · Ohm's Law and Resistance

Four distinct pieces of different dimensions are made from same metal as shown in the figure. Arrange them in the ascending order of resistances. ( In figure x- Cross sectional Area , ℓ\ell- Length of the conductor )

Thinking a thicker wire has more resistance

A thicker wire gives the current more room, so its resistance is less. Resistance falls as the area of cross-section grows.

Forgetting that area goes as the radius squared

Doubling the radius makes the area 4 times, not 2 times, so the resistance becomes one quarter, not one half.

Comparing pieces of different metals by l/A alone

Comparing l/A works only for pieces of the same material. Different metals have different resistivities, which must be included.

Concept 3 of 3: Resistivity of materials and the effect of temperature

Resistance belongs to one particular wire; resistivity belongs to the material it is made of. A long copper wire and a short copper wire have different resistances but exactly the same resistivity, just as a big and a small gold coin have the same density.

Definition

  • Resistivity (ρ) is a property of the material. It does not change with the length or thickness of the wire.
  • Its unit is the ohm metre (Ω m).
  • Silver and copper have the lowest resistivity, which is why copper is used for wires. Alloys such as nichrome have a much higher resistivity, so they are used for heating coils.
  • The resistance of a metal increases when it is heated and decreases when it is cooled.
  • Cooled close to absolute zero (0 K, which is about −273 °C), some materials lose all their resistance: they become superconductors. Mercury does this at about 4 K.
MaterialResistivity at 20 °C (Ω m)Use or note
Silver1.6 × 10⁻⁸The best conductor
Copper1.7 × 10⁻⁸Electric wires
Aluminium2.7 × 10⁻⁸Overhead power lines
Tungsten5.6 × 10⁻⁸Bulb filaments
Platinum10.6 × 10⁻⁸Hardly reacts, so used in special wires and contacts
Nichrome (an alloy)About 1.1 × 10⁻⁶Heating coils of irons and heaters
In increasing order: silver, copper, aluminium, tungsten, platinum, nichrome. Alloys come last.
Practise this conceptself-check · 4 quick reps

The same idea in a real exam question:

Homi Bhabha Class 9 · 2021 · Homi Bhabha Std IX (21 November 2021, online) · Q27Moderate

Example 3 · Current Electricity · Ohm's Law and Resistance

Select the correct ascending order of resistivity of given metals. x - Aluminium, y - Platinum , z - Copper , w- Nichrome

Treating resistivity like resistance

Cutting, stretching or thickening a wire changes its resistance, but its resistivity stays the same as long as the material and temperature do not change.

Thinking resistance vanishes at 0 °C

0 °C is only the freezing point of water. Resistance nearly vanishes close to absolute zero, 0 K, which is about −273 °C.

Writing the unit of resistivity as the ohm

Resistance is measured in ohms; resistivity is measured in ohm metres (Ω m).

Summary — formulas & gotchas at a glance

A revision cheat-sheet for the formulas and gotchas above. Click any concept name to jump back to its full explanation.

Formulas (2)

Reference tables (1)

Resistivity of materials and the effect of temperature6 rows
MaterialResistivity at 20 °C (Ω m)Use or note
Silver1.6 × 10⁻⁸The best conductor
Copper1.7 × 10⁻⁸Electric wires
Aluminium2.7 × 10⁻⁸Overhead power lines
Tungsten5.6 × 10⁻⁸Bulb filaments
Platinum10.6 × 10⁻⁸Hardly reacts, so used in special wires and contacts
Nichrome (an alloy)About 1.1 × 10⁻⁶Heating coils of irons and heaters
In increasing order: silver, copper, aluminium, tungsten, platinum, nichrome. Alloys come last.

Watch out for (8)

Test yourself on a real paper

Sit a past Homi Bhabha Class 9 paper, timed and marked the way the exam marks it. You see your score and every answer the moment you finish. Free to start.