PYQ Vault

NEET Chemistry · Solutions

Colligative Properties

Properties that depend only on the number of solute particles: relative lowering of vapour pressure, elevation of boiling point, depression of freezing point and osmotic pressure, with the van 't Hoff factor for solutes that dissociate or associate.

Why this matters

Four NEET questions from 2021 to 2025. One ranks solutions of 10 g of glucose, urea and sucrose in 250 mL by osmotic pressure (2021), one finds the temperature from the slope of a plot of osmotic pressure against concentration (NEET 2024), one finds the mass of glucose isotonic with a 15 g/L urea solution (Re-NEET 2024), and one picks the highest boiling point among urea, KNO₃, Na₂SO₄ and glucose solutions (2025).

Concept 1 of 2: Boiling point, freezing point and the van 't Hoff factor

A non-volatile solute takes up part of the surface, so fewer solvent molecules escape and the vapour pressure falls. The solution then has to be heated further before its vapour pressure reaches the atmospheric pressure, so it boils higher; it also freezes lower than the pure solvent. These changes depend only on how many solute particles there are, not on what they are. A salt that splits into ions gives more particles, and the van 't Hoff factor counts them.

Definition

  • Colligative properties depend on the number of solute particles, not on their nature: relative lowering of vapour pressure, elevation of boiling point, depression of freezing point and osmotic pressure.
  • Relative lowering of vapour pressure for a non-volatile solute equals the mole fraction of the solute: p1∘−p1p1∘=x2\dfrac{p_1^\circ - p_1}{p_1^\circ} = x_2.
  • Elevation of boiling point: ΔTb=Kbm\Delta T_b = K_b m. For water Kb=0.52 K kg mol−1K_b = 0.52\ \text{K kg mol}^{-1}.
  • Depression of freezing point: ΔTf=Kfm\Delta T_f = K_f m. For water Kf=1.86 K kg mol−1K_f = 1.86\ \text{K kg mol}^{-1}.
  • Molar mass of the solute from either: M2=K×w2×1000ΔT×w1M_2 = \dfrac{K \times w_2 \times 1000}{\Delta T \times w_1}, with w2w_2 grams of solute in w1w_1 grams of solvent.
  • van 't Hoff factor ii = normal molar mass ÷ abnormal molar mass = observed colligative property ÷ calculated colligative property. For a solute that dissociates or associates, multiply by i: ΔTb=iKbm\Delta T_b = iK_b m, ΔTf=iKfm\Delta T_f = iK_f m.
  • A strong electrolyte gives i equal to its number of ions: KCl 2, K2SO4\text{K}_2\text{SO}_4 3. A non-electrolyte such as glucose or urea has i = 1.
  • Dissociation into n ions with degree α\alpha: i=1+(n−1)αi = 1 + (n - 1)\alpha. Association into dimers, as ethanoic acid does in benzene: i=1−α2i = 1 - \dfrac{\alpha}{2}, so i is less than 1.
  • To compare solutions, compare i×mi \times m: the larger it is, the higher the boiling point and the lower the freezing point.

Boiling point, freezing point and the van 't Hoff factor

p1∘−p1p1∘=x2,ΔTb=iKbm,ΔTf=iKfm,i=1+(n−1)α\frac{p_1^\circ - p_1}{p_1^\circ} = x_2, \qquad \Delta T_b = iK_b m, \qquad \Delta T_f = iK_f m, \qquad i = 1 + (n - 1)\alpha
  • mmmolality, moles of solute per kg of solvent
  • Kb,KfK_b, K_febullioscopic and cryoscopic constants of the solvent
  • iivan 't Hoff factor, the number of particles each formula unit gives in solution
  • α\alphadegree of dissociation or association

Diagram · why a solution boils at a higher temperature

vapour pressuretemperature1 atm (outside pressure)pure solventsolution (lower)Tb°TbΔTb

Example: 2 g of solute (M = 80 g mol⁻¹) in 50 g of solvent: m = (2/80)/0.05 = 0.5 mol kg⁻¹. It boils 0.9 K higher, so Kb = ΔTb/m = 0.9/0.5 = 1.8 K kg mol⁻¹.

A liquid boils when its vapour pressure equals the outside pressure. Solute particles lower the vapour pressure, so the solution must be heated further to reach 1 atm: Tb = Tb° + ΔTb, with ΔTb = Kb·m. The gap is drawn larger than 0.9 K so it can be seen.

Worked example

1.8 g of glucose (molar mass 180 g/mol) is dissolved in 100 g of water. Find the boiling point of the solution. (KbK_b for water = 0.52 K kg mol⁻¹; water boils at 373.15 K.)
Practise this conceptself-check · 4 quick reps

The same idea in a real exam question:

NEET · 2025 · NEET (UG) 2025 — 04 May 2025 · Q79Moderate

Example 1 · Solutions · Colligative Properties

Which of the following aqueous solution will exhibit highest boiling point?

Count the ions, not the formula units

0.01 M Na2SO4\text{Na}_2\text{SO}_4 gives 3 ions per formula unit, so it acts like 0.03 M of particles. A non-electrolyte at a higher concentration can still give fewer particles.

Association makes i less than 1

When solute molecules pair up, as ethanoic acid does in benzene, there are fewer particles than formula units. Then i is below 1 and the measured molar mass comes out larger than the true one.

The freezing point falls, the boiling point rises

Subtract ΔTf\Delta T_f from the solvent's freezing point and add ΔTb\Delta T_b to its boiling point. The solution with the largest i×mi \times m has the lowest freezing point.

Concept 2 of 2: Osmotic pressure and isotonic solutions

Put a solution and the pure solvent on the two sides of a membrane that lets only solvent molecules through. Solvent flows into the solution: this is osmosis. The extra pressure you must put on the solution to just stop that flow is its osmotic pressure. It follows the same form as the gas law, with the molar concentration of solute particles in place of n/V.

Definition

  • Osmosis is the flow of solvent through a semipermeable membrane from the pure solvent (or a dilute solution) into the more concentrated solution.
  • Osmotic pressure π\pi is the extra pressure applied to the solution that just stops osmosis: π=CRT=n2VRT\pi = CRT = \dfrac{n_2}{V}RT. For a solute that dissociates or associates, π=iCRT\pi = iCRT.
  • A plot of π\pi against C at a fixed temperature is a straight line through the origin, with slope RT.
  • Molar mass: M2=w2RTπVM_2 = \dfrac{w_2RT}{\pi V}. This is the preferred method for proteins and polymers: it works at room temperature and gives a large value even for a very dilute solution.
  • Isotonic solutions have the same osmotic pressure at the same temperature, so the same iCiC. A 0.9% (mass/volume) sodium chloride solution, normal saline, is isotonic with the fluid inside blood cells.
  • In a hypertonic solution (higher osmotic pressure) a cell loses water and shrinks; in a hypotonic one it takes in water and swells.
  • Reverse osmosis: a pressure larger than the osmotic pressure, applied to the solution side, pushes pure solvent out through the membrane. It is used to desalinate sea water.

Osmotic pressure

π=iCRT=i n2RTV,M2=w2RTπV\pi = iCRT = \frac{i\,n_2RT}{V}, \qquad M_2 = \frac{w_2RT}{\pi V}
  • CCmolar concentration of the solute, in mol per litre
  • RRgas constant, 0.083 L bar per mol per K
  • TTtemperature in kelvin

Worked example

3.42 g of sucrose (molar mass 342 g/mol) is dissolved in water to make 500 mL of solution. Find its osmotic pressure at 300 K. (R = 0.083 L bar mol⁻¹ K⁻¹)
Practise this conceptself-check · 4 quick reps

The same idea in a real exam question:

NEET · 2024 · NEET (UG) 2024 — 05 May 2024 · Q94Moderate

Example 2 · Solutions · Colligative Properties

The plot of osmotic pressure (Π)(\Pi) vs concentration (mol L−1L^{-1}) for a solution gives a straight line with slope 25.73 L bar mol−1mol^{-1}. The temperature at which the osmotic pressure measurement is done is (Use R = 0.083 L bar mol−1mol^{-1} K−1K^{-1})

Use the temperature in kelvin

In π=CRT\pi = CRT, T is in kelvin: 37 °C is 310 K. A temperature found from the formula comes out in kelvin, so subtract 273 to give it in °C.

Equal masses do not give equal osmotic pressure

10 g of urea (60 g/mol) holds more moles than 10 g of glucose (180 g/mol), so in the same volume urea gives the higher osmotic pressure. Convert mass to moles first.

Isotonic means equal particle concentration

Two solutions are isotonic when iCiC is the same, not when the grams per litre are the same. Different molar masses need different masses for the same molarity.

Summary — formulas & gotchas at a glance

A revision cheat-sheet for the formulas and gotchas above. Click any concept name to jump back to its full explanation.

Formulas (2)

  • Boiling point, freezing point and the van 't Hoff factor

    Boiling point, freezing point and the van 't Hoff factor

    p1∘−p1p1∘=x2,ΔTb=iKbm,ΔTf=iKfm,i=1+(n−1)α\frac{p_1^\circ - p_1}{p_1^\circ} = x_2, \qquad \Delta T_b = iK_b m, \qquad \Delta T_f = iK_f m, \qquad i = 1 + (n - 1)\alpha
  • Osmotic pressure and isotonic solutions

    Osmotic pressure

    π=iCRT=i n2RTV,M2=w2RTπV\pi = iCRT = \frac{i\,n_2RT}{V}, \qquad M_2 = \frac{w_2RT}{\pi V}

Watch out for (6)

Test yourself on a real paper

Sit a past NEET paper, timed and marked the way the exam marks it. You see your score and every answer the moment you finish. Free to start.

Sit a NEET past paper