PYQ Vault

NEET Physics · Electromagnetic Induction

Self and Mutual Inductance

Mutual inductance M links the current in one coil to the flux through another, self-inductance L links a coil's current to its own flux, an inductor's emf is L dI/dt, and a current I stores energy ½LI².

Why this matters

Six NEET questions from 2021 to 2026, four of them from 2024 or later. One asks how the mutual inductance of a small loop at the centre of a large one depends on the radii (2021). Two are about a solenoid's self-inductance: a ratio for two solenoids (Re-NEET 2024) and the formula itself (Re-NEET 2026). Two ask for the emf across inductors in a circuit: a branch with an inductor, a cell and a resistor (2025) and identical inductors joined two ways (Re-NEET 2026). One asks for the energy stored in an inductor (2023).

Concept 1 of 4: Mutual inductance of two coils

A current in one coil sends magnetic flux through a nearby coil, and that flux is proportional to the current. The constant is the mutual inductance M. Change the current in the first coil and the second coil gets an emf. M is the same whichever coil carries the current, so work out the flux through the coil where the field is easiest to find.

Definition

  • A current I1I_1 in coil 1 gives a flux linkage N2Φ2=MI1N_2\Phi_2 = MI_1 in coil 2, and ε2=−M dI1dt\varepsilon_2 = -M\,\dfrac{dI_1}{dt}.
  • M12=M21M_{12} = M_{21}: the same M works both ways. SI unit: the henry, 1 H=1 Wb/A1\ \text{H} = 1\ \text{Wb/A}.
  • Two long coaxial solenoids of length l, inner radius r1r_1, with n1n_1 and n2n_2 turns per unit length: M=μ0n1n2πr12lM = \mu_0 n_1 n_2 \pi r_1^{2} l. With a core of relative permeability μr\mu_r: M=μrμ0n1n2πr12lM = \mu_r\mu_0 n_1 n_2 \pi r_1^{2} l.
  • A small loop at the centre of a large one: pass the current through the large loop, whose field μ0I2R\dfrac{\mu_0 I}{2R} at its centre is nearly uniform over the small loop, and find the flux through the small loop.
  • M depends on the shapes, sizes, separation and orientation of the coils and on the material around them, not on the current.

Mutual inductance

ε2=−MdI1dt,M=μ0n1n2πr12l\varepsilon_2 = -M\frac{dI_1}{dt}, \qquad M = \mu_0 n_1 n_2 \pi r_1^{2} l
  • n1,n2n_1, n_2turns per unit length of the two solenoids
  • r1r_1radius of the inner solenoid
  • lllength of the solenoids

Worked example

Two long coaxial solenoids are 0.5 m long. The inner one has radius 2 cm and 1000 turns per metre; the outer one has 2000 turns per metre. Find their mutual inductance, and the emf in the outer solenoid when the current in the inner one changes at 10 A/s.
Practise this conceptself-check · 4 quick reps

The same idea in a real exam question:

NEET · 2021 · NEET (UG) 2021 — 12 Sep 2021 · Q36Moderate

Example 1 · Electromagnetic Induction · Self and Mutual Inductance

Two conducting circular loops of radii R1R_1 and R2R_2 are placed in the same plane with their centres coinciding. If R1>>R2R_1 >> R_2, the mutual inductance MM between them will be directly proportional to

Finding the flux through the wrong loop

For a small loop inside a large one, the large loop's field is easy to find at its centre, but the small loop's field over the large loop is not. Pass the current through the large loop and find the flux through the small one; M is the same either way.

Coaxial solenoids use the inner radius

Only the inner solenoid's cross-section carries flux common to both coils, so M uses πr12\pi r_1^{2} of the inner solenoid, whichever one carries the current.

Concept 2 of 4: Self-inductance of a solenoid

A coil's own current makes a flux through its own turns, and that flux is proportional to the current. The constant is the self-inductance L. When the current changes, the coil induces an emf in itself that opposes the change. L plays the part of inertia for current, just as mass resists a change of velocity. It depends on the coil's shape and on the material inside it, not on the current.

Definition

  • NΦ=LIN\Phi = LI, and the self-induced emf is ε=−L dIdt\varepsilon = -L\,\dfrac{dI}{dt}. Unit: the henry.
  • Long solenoid of length l, area A, n turns per unit length (N=nlN = nl turns in all): L=μ0n2Al=μ0N2AlL = \mu_0 n^{2}Al = \dfrac{\mu_0 N^{2}A}{l}.
  • For a round solenoid of radius r, A=πr2A = \pi r^{2}, so L=μ0πn2r2lL = \mu_0\pi n^{2}r^{2}l.
  • Filled with a core of relative permeability μr\mu_r: L=μrμ0n2AlL = \mu_r\mu_0 n^{2}Al.
  • So L∝n2AlL \propto n^{2}Al: a change in n counts twice.

Self-inductance of a solenoid

ε=−LdIdt,L=μrμ0n2Al\varepsilon = -L\frac{dI}{dt}, \qquad L = \mu_r\mu_0 n^{2}Al
  • nnturns per unit length
  • AAarea of cross-section
  • μr\mu_rrelative permeability of the core (1 for air)

Worked example

An air-cored solenoid 0.5 m long has 500 turns and a cross-section of 10 cm210\ \text{cm}^{2}. Find its self-inductance. What does it become when a core of relative permeability 100 fills it?
Practise this conceptself-check · 4 quick reps

The same idea in a real exam question:

NEET · 2024 · Re-NEET (UG) 2024 — 23 Jun 2024 · Q28Moderate

Example 2 · Electromagnetic Induction · Self and Mutual Inductance

Let us consider two solenoids AA and BB, made from same magnetic material of relative permeability μr\mu_r and equal area of cross-section. Length of AA is twice that of BB and the number of turns per unit length in AA is half that of BB. The ratio of self inductances of the two solenoids, LA:LBL_A : L_B is

Turns per unit length, not total turns

In L=μ0n2AlL = \mu_0 n^{2}Al, n is the number of turns per unit length. With the total number of turns N, the formula is μ0N2A/l\mu_0 N^{2}A/l. Mixing the two gives a factor of l2l^{2} wrong.

n is squared

L goes as n2n^{2}, so halving the turns per unit length cuts L to a quarter, not a half. The length and the area enter only to the first power.

L does not depend on the current

A larger current gives a larger flux, but the ratio NΦ/IN\Phi/I stays the same. L changes only with the coil's size, turns or core.

Concept 3 of 4: Inductors in a circuit

In a circuit an inductor behaves like a small cell whose emf L dI/dt appears only while the current is changing. When the current rises, the inductor pushes back, so the potential drops across it in the direction of the current. When the current falls, it pushes the current on. With a steady current an ideal inductor is just a piece of wire.

Definition

  • Across an inductor, in the direction of the current, the potential falls by L dIdtL\,\dfrac{dI}{dt}. If the current is falling, dI/dt is negative and the potential rises instead.
  • Walking along a branch from A to B: subtract IRIR for each resistor, L dI/dtL\,dI/dt for each inductor and E for each cell crossed from its + to its − terminal (add E for − to +). What is left is VBV_B.
  • Steady current: dI/dt=0dI/dt = 0, so there is no potential difference across an ideal inductor.
  • Inductors far enough apart that mutual inductance can be neglected: in series they carry one current and their emfs add, L=L1+L2L = L_1 + L_2; in parallel they share one emf and their currents add, 1L=1L1+1L2\dfrac{1}{L} = \dfrac{1}{L_1} + \dfrac{1}{L_2}.
  • Two identical inductors in parallel carry half the current each.

Inductor in a circuit

VL=LdIdt,Lseries=L1+L2,1Lparallel=1L1+1L2V_L = L\frac{dI}{dt}, \qquad L_{\text{series}} = L_1 + L_2, \qquad \frac{1}{L_{\text{parallel}}} = \frac{1}{L_1} + \frac{1}{L_2}

Worked example

A current flows from P to Q through a 2 Ω resistor and then a 0.5 H inductor in series. At one instant the current is 3 A and is falling at 4 A/s. Find VP−VQV_P - V_Q.
Practise this conceptself-check · 4 quick reps

The same idea in a real exam question:

NEET · 2025 · NEET (UG) 2025 — 04 May 2025 · Q11Moderate

Example 3 · Electromagnetic Induction · Self and Mutual Inductance

ABAB is a part of an electrical circuit (see figure). The potential difference VA−VBV_A - V_B, at the instant when current i=2i = 2 A and is increasing at a rate of 1 amp/second is: (branch has a 1 H inductor, a 5 V cell and a 2Ω\Omega resistor in series)

Sign of dI/dt when the current falls

For a falling current, L dI/dtL\,dI/dt is negative, so the potential rises across the inductor in the direction of the current. The inductor then acts with the current, not against it.

An inductor with a steady current

An ideal inductor has no resistance. With a steady current there is no voltage across it at all; it is not a drop of LILI.

Parallel inductors combine like resistors

Inductors (with no mutual inductance) add in series and combine by reciprocals in parallel, the same rules as resistors, not the rules for capacitors.

Concept 4 of 4: Energy stored in an inductor

To build up a current in a coil you must push against its back emf, and that work is not lost: it is stored in the coil's magnetic field. The energy depends only on the final current, just as kinetic energy depends only on the final speed. Here L plays the part of mass and I the part of velocity.

Definition

  • Work done to raise the current from 0 to I: W=12LI2W = \tfrac12 LI^{2}. This energy is stored in the magnetic field of the inductor.
  • It matches kinetic energy 12mv2\tfrac12 mv^{2}, with L in place of m and I in place of v.
  • Energy goes as I2I^{2}: doubling the current stores four times the energy.
  • Keep the prefixes: 1 μH is 10−6 H10^{-6}\ \text{H} and 1 mH is 10−3 H10^{-3}\ \text{H}.

Energy in an inductor

U=12LI2U = \tfrac12 LI^{2}

Worked example

The current in a 0.2 H coil is raised from 2 A to 4 A. How much extra energy is stored in its magnetic field?
Practise this conceptself-check · 4 quick reps

The same idea in a real exam question:

NEET · 2023 · NEET (UG) 2023 — 07 May 2023 · Q24Easy

Example 4 · Electromagnetic Induction · Self and Mutual Inductance

The magnetic energy stored in an inductor of inductance 4 μH4\,\mu H carrying a current of 2 A2\,A is

Energy goes as the square of the current

Half the current stores a quarter of the energy, not a half. Square the current before multiplying by L/2.

Losing the prefix

An inductance in microhenry with a current of a few amperes gives an energy in microjoule. Writing μH as mH makes the answer a thousand times too big.

Summary — formulas & gotchas at a glance

A revision cheat-sheet for the formulas and gotchas above. Click any concept name to jump back to its full explanation.

Formulas (4)

  • Mutual inductance of two coils

    Mutual inductance

    ε2=−MdI1dt,M=μ0n1n2πr12l\varepsilon_2 = -M\frac{dI_1}{dt}, \qquad M = \mu_0 n_1 n_2 \pi r_1^{2} l
  • Self-inductance of a solenoid

    Self-inductance of a solenoid

    ε=−LdIdt,L=μrμ0n2Al\varepsilon = -L\frac{dI}{dt}, \qquad L = \mu_r\mu_0 n^{2}Al
  • Inductors in a circuit

    Inductor in a circuit

    VL=LdIdt,Lseries=L1+L2,1Lparallel=1L1+1L2V_L = L\frac{dI}{dt}, \qquad L_{\text{series}} = L_1 + L_2, \qquad \frac{1}{L_{\text{parallel}}} = \frac{1}{L_1} + \frac{1}{L_2}
  • Energy stored in an inductor

    Energy in an inductor

    U=12LI2U = \tfrac12 LI^{2}

Watch out for (10)

Test yourself on a real paper

Sit a past NEET paper, timed and marked the way the exam marks it. You see your score and every answer the moment you finish. Free to start.

Sit a NEET past paper