NEET Physics · Semiconductor Electronics
Rectifiers and Special Diodes
How one or two diodes turn ac into dc, how a capacitor smooths the output, the Zener diode as a voltage regulator, and the LED, photodiode and solar cell.
Why this matters
Eight NEET questions from 2022 to 2026, five of them from 2024 or later. Four are about rectifiers: the output frequency of a half-wave rectifier, the part that removes the ripple, which diode conducts at a given instant, and the voltage across a diode. Two are about the Zener diode (one of them also about photovoltaic devices) and two about the solar cell and its I-V curve.
Concept 1 of 3: Half-wave and full-wave rectifiers
Definition
- Half-wave: one diode. The load gets a pulse in one half cycle and nothing in the other. The output pulses at the same frequency as the input.
- Full-wave: a centre-tapped transformer and two diodes. One diode conducts in the positive half, the other in the negative half, and the current through the load is in the same direction both times. The output pulses at twice the input frequency.
- Filter: a capacitor across the load removes the ac ripple. It charges to the peak voltage and discharges slowly through the load, so the output is nearly steady dc.
- For , the period is . The positive half cycle runs from 0 to , the negative half from to T.
- Peak and rms: .
- In a half-wave rectifier the input voltage appears across the diode in the half cycle when it is reverse biased; while it conducts, an ideal diode has no voltage across it.
Rectifier output
- frequency of the ac input
- peak voltage
Animation · half-wave and full-wave rectifiers
- Input a.c.: The a.c. input is positive for one half of each cycle and negative for the other. Here f = 60 Hz, so 60 cycles every second.
- Half-wave rectifier: A single diode conducts only on the positive halves. It blocks the negative halves, so the output is zero for them.
- Half-wave output: One pulse per cycle: the pulsating d.c. keeps the input frequency, f = 60 Hz.
- Full-wave rectifier: Two diodes with a centre-tapped transformer (or a bridge) pass both halves the same way round, so each negative half comes out positive.
- Full-wave output: Two pulses per cycle: the output is at twice the input frequency, 2f = 120 Hz. Answering 60 Hz for both rectifiers is the trap.
Without a filter both outputs are pulsating d.c., not steady d.c. For steady d.c. the order is rectifier, then filter, then regulator.
Worked example
Practise this conceptself-check · 4 quick reps
The same idea in a real exam question:
Example 1 · Semiconductor Electronics · Rectifiers and Special Diodes
Only full-wave doubles the frequency
Find the half cycle from the period
A filter charges to the peak, not the rms
Concept 2 of 3: The Zener diode as a voltage regulator
Definition
- Both the p and n sides are heavily doped. A Zener is used in reverse bias, in the breakdown region.
- Regulator: supply , then a series resistor , then the Zener (reverse biased) in parallel with the load . The load voltage is .
- Current in the series resistor: . Load current: . Zener current: .
- If the input rises, the extra voltage drops across and the Zener current rises; the output stays at .
- Forward biased, a Zener behaves like an ordinary diode.
Zener regulator
- Zener (breakdown) voltage
- series resistor
- load resistor
Worked example
Practise this conceptself-check · 4 quick reps
The same idea in a real exam question:
Example 2 · Semiconductor Electronics · Rectifiers and Special Diodes
The Zener takes what the load does not
A change in supply lands on the resistor
Concept 3 of 3: LED, photodiode and solar cell
Definition
- Photon energy and wavelength: .
- LED: heavily doped and forward biased. The light has a photon energy close to the band gap; visible light (about 1.8 eV to 3 eV) needs a gap of at least about 1.8 eV. Compared with a filament bulb, an LED works at low voltage and low power, needs no warm-up time, switches on and off fast, and has a long life.
- Photodiode: reverse biased. Light with photon energy above the band gap makes electron-hole pairs. The reverse current is small, so this changes it by a large fraction, which is why a photodiode measures light intensity in reverse bias.
- Solar cell: no external bias. Light makes an emf (photovoltaic action), and the cell drives current through a load. Its I-V curve is drawn in the fourth quadrant. Semiconductors with a band gap near 1.5 eV, such as Si and GaAs, are the best materials.
| Device | Bias in use | What it does | Key fact |
|---|---|---|---|
| Zener diode | reverse, at breakdown | holds the voltage across it constant | both sides heavily doped |
| LED | forward | gives out light when electrons and holes recombine | photon energy close to the band gap |
| Photodiode | reverse | light makes electron-hole pairs and raises the reverse current | used to measure light intensity |
| Solar cell | no external bias | turns light into electricity | I-V curve in the fourth quadrant; band gap near 1.5 eVQ Re-NEET 2024: an I-V curve lying in the fourth quadrant was to be named, and it was the solar cell's. |
Practise this conceptself-check · 4 quick reps
The same idea in a real exam question:
Example 3 · Semiconductor Electronics · Rectifiers and Special Diodes
A photodiode works in reverse bias
Use 1240 with energies in eV
Summary — formulas & gotchas at a glance
A revision cheat-sheet for the formulas and gotchas above. Click any concept name to jump back to its full explanation.
Formulas (2)
- Half-wave and full-wave rectifiers
Rectifier output
- The Zener diode as a voltage regulator
Zener regulator
Reference tables (1)
LED, photodiode and solar cell4 rows
| Device | Bias in use | What it does | Key fact |
|---|---|---|---|
| Zener diode | reverse, at breakdown | holds the voltage across it constant | both sides heavily doped |
| LED | forward | gives out light when electrons and holes recombine | photon energy close to the band gap |
| Photodiode | reverse | light makes electron-hole pairs and raises the reverse current | used to measure light intensity |
| Solar cell | no external bias | turns light into electricity | I-V curve in the fourth quadrant; band gap near 1.5 eVQ Re-NEET 2024: an I-V curve lying in the fourth quadrant was to be named, and it was the solar cell's. |
Watch out for (7)
- Only full-wave doubles the frequency→ Half-wave and full-wave rectifiers
- Find the half cycle from the period→ Half-wave and full-wave rectifiers
- A filter charges to the peak, not the rms→ Half-wave and full-wave rectifiers
- The Zener takes what the load does not→ The Zener diode as a voltage regulator
- A change in supply lands on the resistor→ The Zener diode as a voltage regulator
- A photodiode works in reverse bias→ LED, photodiode and solar cell
- Use 1240 with energies in eV→ LED, photodiode and solar cell
Test yourself on a real paper
Sit a past NEET paper, timed and marked the way the exam marks it. You see your score and every answer the moment you finish. Free to start.