PYQ Vault

NEET Physics · Thermal Properties of Matter

Heat Transfer and Cooling

Conduction through a rod or slab (H = KAΔT/L) and rods joined in series, the three ways heat moves and why trapped air insulates, then Newton's law of cooling.

Why this matters

Three NEET questions. NEET 2025 joins three rods in series and asks for the ratio of the two junction temperatures. Re-NEET 2024 gives an assertion about a foam layer on a concrete roof. NEET 2021 has a cup of coffee cooling in two stages in the same room.

Concept 1 of 3: Conduction and rods in series

Heat flows along a rod from the hot end to the cold end, much as charge flows along a wire from high potential to low. The temperature difference plays the part of the voltage, the rate of heat flow the part of the current, and L/KA the part of the resistance. Once the rod reaches the steady state, its temperatures stop changing and the same heat current passes every cross-section.

Definition

  • Heat current through a rod or slab: H=KA(T1−T2)LH = \dfrac{KA(T_1 - T_2)}{L}, where K is the thermal conductivity.
  • Thermal resistance: R=LKAR = \dfrac{L}{KA}, so H=T1−T2RH = \dfrac{T_1 - T_2}{R}.
  • Rods in series carry the same H. Add their resistances: R=R1+R2+…R = R_1 + R_2 + \dots
  • Rods in parallel share the same temperature difference. Add 1R\dfrac{1}{R}, that is add KAL\dfrac{KA}{L}.
  • A junction temperature: find H from the whole chain, then the drop across one rod is HRHR for that rod. The drops are in the ratio of the resistances.

Heat conduction

H=KA(T1−T2)L,R=LKA,Rseries=R1+R2+…H = \frac{KA(T_1 - T_2)}{L}, \qquad R = \frac{L}{KA}, \qquad R_{series} = R_1 + R_2 + \dots
  • HHheat flowing per second
  • KKthermal conductivity
  • RRthermal resistance

Worked example

A copper rod 0.5 m long with a cross-section of 4 cm² has its ends at 100 °C and 0 °C. Find the heat flowing through it each second in the steady state. (K=400 W m−1K−1K = 400\ \text{W m}^{-1}\text{K}^{-1})
Practise this conceptself-check · 4 quick reps

The same idea in a real exam question:

NEET · 2025 · NEET (UG) 2025 — 04 May 2025 · Q19Hard

Example 1 · Thermal Properties of Matter · Heat Transfer and Cooling

Three identical heat conducting rods are connected in series as shown in the figure. The rods on the sides have thermal conductivity 2K2K while that in the middle has thermal conductivity KK. The left end of the combination is maintained at temperature 3T3T and the right end at TT. The rods are thermally insulated from outside. In steady state, temperature at the left junction is T1T_1 and that at the right junction is T2T_2. The ratio T1/T2T_1/T_2 is

In series, add resistances, not conductivities

For rods in series add LKA\dfrac{L}{KA} for each rod. Adding the conductivities treats them as if they were side by side.

The poorer conductor takes the bigger drop

The same heat current flows through rods in series, so the temperature drop across each is HRHR. The rod with the larger thermal resistance (smaller K for the same size) has the larger drop.

Steady state does not mean equal temperatures

In the steady state the temperature at each point stops changing, but it still falls along the rod. What is equal everywhere is the heat current, not the temperature.

Concept 2 of 3: Conduction, convection, radiation and insulators

Heat moves in three ways. In conduction it is passed from particle to particle while the material stays in place. In convection the warm fluid itself moves and carries the heat with it. In radiation it travels as electromagnetic waves and needs no medium at all. An insulator works by blocking these paths, and still, trapped air is one of the best.

Definition

  • Conduction happens mainly in solids. Metals are good conductors; wood, glass and air are poor ones.
  • Convection happens only in fluids: warm fluid expands, becomes less dense and rises, and cooler fluid sinks to take its place.
  • Radiation is carried by electromagnetic waves, so it crosses empty space.
  • Trapped air conducts heat poorly and cannot circulate, so materials full of air pockets (foam, wool) insulate well.
Conductionsolid — molecules vibrate in placeneeds a mediumConvectionfluid rises hot, sinks coolRadiationEM waves — no medium neededtravels at speed of light

Conduction and convection both require matter to carry the heat; only radiation crosses a vacuum, which is how the Sun warms the Earth.

IdeaWhat happensExample
ConductionHeat is passed by collisions between neighbouring particles; the material does not moveThe handle of a metal spoon in hot tea warms up
ConvectionWarm fluid rises and cool fluid sinks, carrying heat with the flowA sea breeze by day and a land breeze at night
RadiationHeat is carried by electromagnetic waves and needs no mediumHeat from the Sun reaching the Earth across empty space
InsulationTrapped still air conducts heat poorly and cannot circulate, so little heat gets throughA foam layer on a concrete roof keeps the room cooler in summerQ
Re-NEET 2024: the assertion that a foam layer keeps the room hotter in summer is false; the reason, that foam's air pockets block heat, is true.
AbsorbersA dark surface absorbs radiation well and a shiny white one reflects most of itLight-coloured clothes feel cooler in strong sunshine
Conduction and convection need a medium; radiation does not.
Practise this conceptself-check · 4 quick reps

The same idea in a real exam question:

NEET · 2024 · Re-NEET (UG) 2024 — 23 Jun 2024 · Q23Easy

Example 2 · Thermal Properties of Matter · Heat Transfer and Cooling

Given below are two statements: One is labelled as Assertion A and the other is labelled as Reason R. Assertion A: Houses made of concrete roofs overlaid with foam keep the room hotter during summer. Reason R: The layer of foam insulation prohibits heat transfer, as it contains air pockets. In the light of the above statements, choose the correct answer from the options given below.

Insulation keeps heat out as well as in

An insulating layer slows heat flow in both directions. On a roof in summer it keeps the Sun's heat out, so the room stays cooler, not hotter.

Convection needs a fluid

Convection moves the material itself, so it happens only in liquids and gases. Heat moves through a solid wall by conduction.

Concept 3 of 3: Newton's law of cooling

A hot body in a room loses heat faster the hotter it is than the room. When the difference is small, the rate of cooling is simply proportional to that difference. So a cup of tea cools quickly at first and then more and more slowly as it nears room temperature. Equal drops in temperature take longer and longer.

Definition

  • Newton's law of cooling: for a small difference, the rate of cooling is proportional to the excess temperature: dTdt=−k(T−Ts)\dfrac{dT}{dt} = -k(T - T_s), where TsT_s is the temperature of the surroundings.
  • For a drop from T1T_1 to T2T_2 in a time t, use the average temperature: T1−T2t=k(T1+T22−Ts)\dfrac{T_1 - T_2}{t} = k\left(\dfrac{T_1 + T_2}{2} - T_s\right).
  • Two stages in the same room: find k from the first stage, then use it in the second.
  • A body only approaches the temperature of its surroundings; it does not cool below it.

Newton's law of cooling

dTdt=−k(T−Ts),T1−T2t=k(T1+T22−Ts)\frac{dT}{dt} = -k(T - T_s), \qquad \frac{T_1 - T_2}{t} = k\left(\frac{T_1 + T_2}{2} - T_s\right)
  • TsT_stemperature of the surroundings
  • kka constant for the body and its surface

Worked example

A body at 60 °C in a room at 20 °C is cooling at 2 °C per minute. At what rate does it cool when it has reached 40 °C?
Practise this conceptself-check · 4 quick reps

The same idea in a real exam question:

NEET · 2021 · NEET (UG) 2021 — 12 Sep 2021 · Q28Moderate

Example 3 · Thermal Properties of Matter · Heat Transfer and Cooling

A cup of coffee cools from 90°C to 80°C in tt minutes, when the room temperature is 20°C. The time taken by a similar cup of coffee to cool from 80°C to 60°C at a room temperature same at 20°C is

Average the temperatures, then subtract the room

In the average form the excess is T1+T22−Ts\dfrac{T_1 + T_2}{2} - T_s. Taking the excess at the start, or averaging the drop, gives a wrong k.

Equal drops take longer near room temperature

As the body nears the room's temperature the excess is smaller, so it cools more slowly. A drop of 20 °C closer to room temperature takes more time than a drop of 20 °C higher up.

Summary — formulas & gotchas at a glance

A revision cheat-sheet for the formulas and gotchas above. Click any concept name to jump back to its full explanation.

Formulas (2)

  • Conduction and rods in series

    Heat conduction

    H=KA(T1−T2)L,R=LKA,Rseries=R1+R2+…H = \frac{KA(T_1 - T_2)}{L}, \qquad R = \frac{L}{KA}, \qquad R_{series} = R_1 + R_2 + \dots
  • Newton's law of cooling

    Newton's law of cooling

    dTdt=−k(T−Ts),T1−T2t=k(T1+T22−Ts)\frac{dT}{dt} = -k(T - T_s), \qquad \frac{T_1 - T_2}{t} = k\left(\frac{T_1 + T_2}{2} - T_s\right)

Reference tables (1)

Conduction, convection, radiation and insulators5 rows
IdeaWhat happensExample
ConductionHeat is passed by collisions between neighbouring particles; the material does not moveThe handle of a metal spoon in hot tea warms up
ConvectionWarm fluid rises and cool fluid sinks, carrying heat with the flowA sea breeze by day and a land breeze at night
RadiationHeat is carried by electromagnetic waves and needs no mediumHeat from the Sun reaching the Earth across empty space
InsulationTrapped still air conducts heat poorly and cannot circulate, so little heat gets throughA foam layer on a concrete roof keeps the room cooler in summerQ
Re-NEET 2024: the assertion that a foam layer keeps the room hotter in summer is false; the reason, that foam's air pockets block heat, is true.
AbsorbersA dark surface absorbs radiation well and a shiny white one reflects most of itLight-coloured clothes feel cooler in strong sunshine
Conduction and convection need a medium; radiation does not.

Watch out for (7)

Test yourself on a real paper

Sit a past NEET paper, timed and marked the way the exam marks it. You see your score and every answer the moment you finish. Free to start.

Sit a NEET past paper