PYQ Vault

NEET Physics · Current Electricity

Combinations of Resistors

Resistors in series add, resistors in parallel add as reciprocals, and current splits between parallel branches in the inverse ratio of their resistances.

Why this matters

Eight NEET questions from 2021 to 2026, five of them from 2024 or later. Five reduce a set of equal pieces: four wires in parallel then in series, ten resistors switched from series to parallel, a wire cut into parts, and a stretched wire bent into a circle. Three split a current: the share of one branch, the current in a bridging wire, and a circuit whose capacitor has stopped charging.

Concept 1 of 2: Series and parallel combinations

In series the same current must push through every resistor one after another, so the resistances add. In parallel each resistor offers a separate path for the same voltage, so adding a path always lowers the total. A useful check: a parallel total is smaller than the smallest resistor in it.

Definition

  • Series: Rs=R1+R2+…R_s = R_1 + R_2 + \dots. Same current through each, voltages share in proportion to R.
  • Parallel: 1Rp=1R1+1R2+…\dfrac{1}{R_p} = \dfrac{1}{R_1} + \dfrac{1}{R_2} + \dots. Same voltage across each. For two: Rp=R1R2R1+R2R_p = \dfrac{R_1R_2}{R_1 + R_2}.
  • n equal resistors R: series nR, parallel Rn\dfrac{R}{n}, so RsRp=n2\dfrac{R_s}{R_p} = n^{2}. On the same battery the parallel current is n2n^{2} times the series current.
  • A wire of resistance R cut into n equal pieces: each piece is Rn\dfrac{R}{n}.
  • A uniform wire of resistance R bent into a circle: across a diameter the two halves R2\dfrac{R}{2} are in parallel, giving R4\dfrac{R}{4}.

Equivalent resistance

Rs=R1+R2+…,1Rp=1R1+1R2+…,RsRp=n2R_s = R_1 + R_2 + \dots, \qquad \frac{1}{R_p} = \frac{1}{R_1} + \frac{1}{R_2} + \dots, \qquad \frac{R_s}{R_p} = n^{2}
SeriesR₁R₂R₁+R₂same current through bothParallelR₁R₂R₁R₂/(R₁+R₂)same voltage across both

Series adds (always larger); parallel combines by reciprocals (always smaller than the smallest branch). Reduce a network innermost-group first.

Worked example

A wire of resistance 24 Ω is cut into 4 equal pieces. Two pieces are joined in parallel, and this pair is joined in series with the other two pieces. Find the total resistance.
Practise this conceptself-check · 4 quick reps

The same idea in a real exam question:

NEET · 2024 · NEET (UG) 2024 — 05 May 2024 · Q32Moderate

Example 1 · Current Electricity · Combinations of Resistors

A wire of length 'll' and resistance 100 Ω\Omega is divided into 10 equal parts. The first 5 parts are connected in series while the next 5 parts are connected in parallel. The two combinations are again connected in series. The resistance of this final combination is:

Find one piece first

When a wire is cut, each piece carries its share of the original resistance, R/nR/n. Using the whole wire's R for a piece makes every later step wrong.

The current ratio is n squared

Switching n equal resistors from series to parallel on the same battery multiplies the current by n2n^{2}, not n, because the resistance falls from nR to R/n.

Stretch, then bend

A wire stretched to twice its length has four times its resistance before it is bent. Across a diameter the circle then gives a quarter of that new value.

Concept 2 of 2: Current division and steady state

At a junction the current shares out so that every parallel branch has the same voltage across it. That means the branch with less resistance takes more current. A charged capacitor in a DC circuit is like a broken wire: once it is full, no current flows through its branch.

Definition

  • Two branches in parallel carrying a total I: I1=IR2R1+R2I_1 = I\dfrac{R_2}{R_1 + R_2}, I2=IR1R1+R2I_2 = I\dfrac{R_1}{R_1 + R_2}. Each takes the other's resistance on top.
  • Same voltage across parallel branches: I1R1=I2R2I_1R_1 = I_2R_2.
  • The current in a wire joining two junctions is found from the junction rule: what flows in minus what flows out along the other paths.
  • Steady state with a capacitor: its branch carries no current, so remove that branch, then solve the rest. The capacitor's voltage equals the voltage across the points it joins.

Current divider

I1=I R2R1+R2,I2=I R1R1+R2I_1 = I\,\frac{R_2}{R_1 + R_2}, \qquad I_2 = I\,\frac{R_1}{R_1 + R_2}

Worked example

A current of 9 A enters a pair of parallel resistors of 3 Ω and 6 Ω. How much current flows in each?
Practise this conceptself-check · 4 quick reps

The same idea in a real exam question:

NEET · 2021 · NEET (UG) 2021 — 12 Sep 2021 · Q38Moderate

Example 2 · Current Electricity · Combinations of Resistors

Three resistors having resistances r1r_1, r2r_2 and r3r_3 are connected as shown in the given circuit. The ratio i3i1\dfrac{i_3}{i_1} of currents in terms of resistances used in the circuit is

Each branch takes the other's resistance

In I1=IR2/(R1+R2)I_1 = I R_2/(R_1 + R_2) the numerator is the OTHER branch's resistance. Putting R1R_1 on top gives the larger current to the larger resistor, which is backwards.

A full capacitor is an open switch

In the steady state no current flows through a capacitor's branch. Leaving that branch in the resistance calculation gives a wrong total.

Summary — formulas & gotchas at a glance

A revision cheat-sheet for the formulas and gotchas above. Click any concept name to jump back to its full explanation.

Formulas (2)

  • Series and parallel combinations

    Equivalent resistance

    Rs=R1+R2+…,1Rp=1R1+1R2+…,RsRp=n2R_s = R_1 + R_2 + \dots, \qquad \frac{1}{R_p} = \frac{1}{R_1} + \frac{1}{R_2} + \dots, \qquad \frac{R_s}{R_p} = n^{2}
  • Current division and steady state

    Current divider

    I1=I R2R1+R2,I2=I R1R1+R2I_1 = I\,\frac{R_2}{R_1 + R_2}, \qquad I_2 = I\,\frac{R_1}{R_1 + R_2}

Watch out for (5)

Test yourself on a real paper

Sit a past NEET paper, timed and marked the way the exam marks it. You see your score and every answer the moment you finish. Free to start.

Sit a NEET past paper