SSC CGL Tier II Maths · Mensuration 3D
Scaling and Comparing Solids
Areas change with the square of a length and volumes with its cube, so a change in radius or height becomes a product of factors, and two solids compare by ratios with every constant cancelled.
Why this matters
8 questions in the Tier II bank, 7 EASY and 1 MODERATE. None needs a full volume worked out: each is a factor or a ratio, which is why they are among the fastest marks in the chapter.
Concept 1 of 2: Scale factors for area and volume
Definition
- Sphere: surface goes with , volume with .
- Cylinder and cone: volume goes with ; a cylinder's curved surface goes with .
- Write each change as a factor (10% more is 1.1), raise or multiply as the formula says, then subtract 1 for the percentage.
- A length changed by changes an area by per cent, the successive-change rule with itself.
Changes in a solid
Visualization · scale every length by k
Jug: height 12 → 18 cm · glaze 150 → 337.5 cm² · holds 0.8 → 2.7 litres
At k = 2 each big face holds 4 small faces and the big cube holds 8 small cubes. The jugs are 12 cm and 18 cm tall, so k = 1.5: the glaze (an area) is multiplied by 1.5² = 2.25 and the capacity (a volume) by 1.5³ = 3.375.
Worked example
Practise this conceptself-check · 3 quick reps
The same idea in a real exam question:
Example 1 · Mensuration 3D · Scaling and Comparing Solids
Giving the volume the radius's percentage
Concept 2 of 2: Ratios of two solids
Definition
- Two cylinders, or two cones: .
- Two spheres: and .
- Given a ratio of surfaces, take the square root to get the radii; given volumes, the cube root.
- Given the sum and difference of two radii (or of their squares), find each radius first.
Two cylinders or cones
Worked example
Practise this conceptself-check · 3 quick reps
The same idea in a real exam question:
Example 2 · Mensuration 3D · Scaling and Comparing Solids
Reading a surface ratio as a volume ratio
Summary — formulas & gotchas at a glance
A revision cheat-sheet for the formulas and gotchas above. Click any concept name to jump back to its full explanation.
Formulas (2)
- Scale factors for area and volume
Changes in a solid
- Ratios of two solids
Two cylinders or cones
Watch out for (2)
- Giving the volume the radius's percentage→ Scale factors for area and volume
- Reading a surface ratio as a volume ratio→ Ratios of two solids
Test yourself on Mensuration 3D
20 past SSC CGL Tier II questions from this chapter, timed at 19 minutes and marked the way the exam marks it. You see your score and every answer the moment you finish. Free to start.