PYQ Vault

NEET Physics · Formula sheet

Alternating Current formulas

8 formulas and 18 common traps for NEET Physics Alternating Current, grouped by subtopic.

Full notes with worked examples

AC Values and Reactance

Learn this subtopic in the notes

Peak, rms and instantaneous values

AC values

i=I0sin⁡ωt,ω=2πf,Irms=I02,Vrms=V02i = I_0 \sin \omega t, \qquad \omega = 2\pi f, \qquad I_{rms} = \frac{I_0}{\sqrt{2}}, \qquad V_{rms} = \frac{V_0}{\sqrt{2}}
  • I0I_0peak current
  • ω\omegaangular frequency in rad/s
  • fffrequency in hertz

An inductor in an ac circuit

Inductive reactance

XL=ωL=2πfL,V0=I0XLX_L = \omega L = 2\pi f L, \qquad V_0 = I_0 X_L

A capacitor in an ac circuit

Capacitive reactance

XC=1ωC=12πfC,I0=V0ωCX_C = \frac{1}{\omega C} = \frac{1}{2\pi f C}, \qquad I_0 = V_0 \omega C

Common traps

Meters and ratings are rms

220 V mains means 220 V rms. Its peak is 2202≈311 V220\sqrt{2} \approx 311\ \text{V}. An ac ammeter or voltmeter always shows the rms value, never the peak.

Zero to peak is a quarter cycle

A sine current rises from zero to its peak in T4\dfrac{T}{4}, not T2\dfrac{T}{2}. At 50 Hz that is 1200\dfrac{1}{200} s, or 5 ms.

A given ω is already in rad/s

In sin⁡(500t)\sin(500t) or sin⁡(100πt)\sin(100\pi t), the number that multiplies t is ω\omega itself. Use 2πf2\pi f only when the frequency is given in hertz.

In an inductor the voltage leads

The voltage across a pure inductor reaches its peak a quarter cycle before the current does. The current lags the voltage; it does not lead it.

Capacitive reactance falls with frequency

XC=12πfCX_C = \dfrac{1}{2\pi fC} goes down as f or C goes up. Raising the frequency lets more current through a capacitor, unlike an inductor.

In a capacitor the current leads

In a pure capacitor the current leads the voltage by π2\dfrac{\pi}{2}. A memory aid is CIVIL: in C, I leads V; V leads I in L.

Series LCR Circuit and Resonance

Learn this subtopic in the notes

Impedance and phase angle

Series LCR

Z=R2+(XL−XC)2,tan⁡ϕ=XL−XCR,V=VR2+(VL−VC)2Z = \sqrt{R^{2} + (X_L - X_C)^{2}}, \qquad \tan\phi = \frac{X_L - X_C}{R}, \qquad V = \sqrt{V_R^{2} + (V_L - V_C)^{2}}
  • ZZimpedance
  • ϕ\phiphase angle between current and voltage

Resonance in a series LCR circuit

Resonance

ω0=1LC,f0=12πLC,Zmin⁡=R\omega_0 = \frac{1}{\sqrt{LC}}, \qquad f_0 = \frac{1}{2\pi\sqrt{LC}}, \qquad Z_{\min} = R

Power, power factor and half-power frequencies

Power in ac

P=VrmsIrmscos⁡ϕ,cos⁡ϕ=RZ,ω1,2=ω0±R2LP = V_{rms} I_{rms} \cos\phi, \qquad \cos\phi = \frac{R}{Z}, \qquad \omega_{1,2} = \omega_0 \pm \frac{R}{2L}

Common traps

Voltages add as phasors

Readings of 40 V across L, 10 V across C and 40 V across R do not make a 90 V supply. The supply is 402+(40−10)2=50 V\sqrt{40^{2} + (40 - 10)^{2}} = 50\ \text{V}.

Subtract the reactances

XLX_L and XCX_C act in opposite directions, so the impedance uses XL−XCX_L - X_C. Adding them gives an impedance that is too large.

Keep peak with peak

Z=VIZ = \dfrac{V}{I} holds with both values rms or both peak. If the current amplitude is given, divide it by 2\sqrt{2} before using it with an rms voltage.

rad/s or hertz

1LC\dfrac{1}{\sqrt{LC}} is the angular frequency in rad/s. Divide by 2π2\pi for hertz. With L = 10 mH and C = 1 μF, ω0=104\omega_0 = 10^{4} rad/s but f0≈1.59f_0 \approx 1.59 kHz.

Resistance does not move resonance

The resonant frequency depends on L and C only. A resistance given in the question changes the current at resonance, never f0f_0.

Convert milli and micro first

Put L in henry and C in farad before using 1LC\dfrac{1}{\sqrt{LC}}: 10 mH is 10−210^{-2} H and 1 μF is 10−610^{-6} F.

Use rms values for power

P=VIcos⁡ϕP = V I\cos\phi needs rms values. With peak values the power is 12V0I0cos⁡ϕ\dfrac{1}{2}V_0I_0\cos\phi.

Half power is not half current

At a half-power frequency the current is 12\dfrac{1}{\sqrt{2}} of its resonant value, not half. Each half-power frequency sits R2L\dfrac{R}{2L} from ω0\omega_0, so the two are RL\dfrac{R}{L} apart.

LC Oscillations and Transformers

Learn this subtopic in the notes

LC oscillations

LC oscillator

ω=1LC,q22C+12Li2=Q022C,Imax⁡=Q0LC\omega = \frac{1}{\sqrt{LC}}, \qquad \frac{q^{2}}{2C} + \frac{1}{2}Li^{2} = \frac{Q_0^{2}}{2C}, \qquad I_{\max} = \frac{Q_0}{\sqrt{LC}}

Transformers

Transformer

VsVp=NsNp=IpIs,VpIp=VsIs\frac{V_s}{V_p} = \frac{N_s}{N_p} = \frac{I_p}{I_s}, \qquad V_p I_p = V_s I_s
  • Np,NsN_p, N_sturns on the primary and the secondary
  • Vp,VsV_p, V_sprimary and secondary voltages

Common traps

Energy goes as charge squared

Half the largest charge leaves only a quarter of the energy in the capacitor. The other three quarters is in the inductor.

Natural log, not log to base 10

To solve Q=Q0e−Rt/2LQ = Q_0e^{-Rt/2L} for a fall to half, use ln⁡2=0.693\ln 2 = 0.693, not log⁡2=0.301\log 2 = 0.301.

Current changes the other way to voltage

A step-up transformer raises the voltage and lowers the current by the same factor. In an ideal one the power is the same on both sides.

Ratings give the power

A lamp rated 12 V, 60 W on the secondary takes 60 W. An ideal transformer then takes 60 W from the mains too, so the primary current is that power divided by the primary voltage, not by 12 V.

More NEET Physics formula sheets