PYQ Vault

NEET Physics · Formula sheet

Semiconductor Electronics formulas

7 formulas, 2 reference tables and 23 common traps for NEET Physics Semiconductor Electronics, grouped by subtopic.

Full notes with worked examples

Semiconductors and the p-n Junction

Learn this subtopic in the notes

Intrinsic and extrinsic semiconductors

Carriers and conductivity

nenh=ni2,I=eA(neve+nhvh),σ=e(neμe+nhμh)n_e n_h = n_i^{2}, \qquad I = eA(n_e v_e + n_h v_h), \qquad \sigma = e(n_e\mu_e + n_h\mu_h)
  • nin_icarrier density of the pure semiconductor
  • ne,nhn_e, n_helectron and hole densities
  • μe,μh\mu_e, \mu_helectron and hole mobilities

The p-n junction and its bias

Junction relations

E=Vbd,rd=ΔVΔIE = \frac{V_b}{d}, \qquad r_d = \frac{\Delta V}{\Delta I}
  • VbV_bbarrier potential
  • ddwidth of the depletion layer
  • rdr_ddynamic resistance

Diodes in circuits

Diode in series with a resistor

I=E−V0R  (forward),I=0  (reverse, ideal)I = \frac{E - V_0}{R}\ \ \text{(forward)}, \qquad I = 0\ \ \text{(reverse, ideal)}
  • V0V_0forward voltage drop of the diode
  • EEemf of the battery

Common traps

A doped crystal stays neutral

An n-type crystal has more free electrons than holes, but every donor atom that gave an electron is left as a positive ion. The crystal as a whole carries no charge.

The product is fixed, not the sum

Doping raises one carrier density and lowers the other so that nenh=ni2n_e n_h = n_i^{2} still holds. The minority density falls below nin_i; it does not stay at nin_i.

Electrons move more easily than holes

With equal carrier densities and the same field, n-type material carries the larger current, because the electron mobility is greater than the hole mobility.

Compare potentials, not signs

A diode is forward biased when its p-side is at the higher potential. p at −2-2 V and n at −6-6 V is forward bias even though both are negative.

The reverse current is a minority current

The few microamperes through a reverse-biased junction are carried by minority carriers, not majority carriers. The large current above the threshold in forward bias is not the reverse saturation current.

A silicon diode needs about 0.7 V

A silicon diode starts to conduct strongly at about 0.7 V, not at 0.1 to 0.3 V. The 0.2 V figure belongs to germanium.

Forward narrows, reverse widens

Forward bias makes the depletion layer thinner than in an unbiased junction; reverse bias makes it wider. So a reverse-biased diode has the widest layer and a forward-biased one the thinnest.

Decide each diode's bias first

A branch whose diode is reverse biased carries no current, so it drops out of the circuit. Solving as if every diode conducts gives a current that is too large.

Subtract the drop before dividing

With a real diode the current is E−V0R\dfrac{E - V_0}{R}, not ER\dfrac{E}{R}. The diode's own voltage is not available to the resistor.

Rectifiers and Special Diodes

Learn this subtopic in the notes

Half-wave and full-wave rectifiers

Rectifier output

fhalf-wave=f,ffull-wave=2f,T=2πω,Vm=2 Vrmsf_{\text{half-wave}} = f, \qquad f_{\text{full-wave}} = 2f, \qquad T = \frac{2\pi}{\omega}, \qquad V_m = \sqrt{2}\,V_{\text{rms}}
  • fffrequency of the ac input
  • VmV_mpeak voltage

The Zener diode as a voltage regulator

Zener regulator

VL=VZ,IS=Vin−VZRS,IZ=IS−VZRLV_L = V_Z, \qquad I_S = \frac{V_{in} - V_Z}{R_S}, \qquad I_Z = I_S - \frac{V_Z}{R_L}
  • VZV_ZZener (breakdown) voltage
  • RSR_Sseries resistor
  • RLR_Lload resistor

LED, photodiode and solar cell

DeviceBias in useWhat it doesKey fact
Zener diodereverse, at breakdownholds the voltage across it constantboth sides heavily doped
LEDforwardgives out light when electrons and holes recombinephoton energy close to the band gap
Photodiodereverselight makes electron-hole pairs and raises the reverse currentused to measure light intensity
Solar cellno external biasturns light into electricityI-V curve in the fourth quadrant; band gap near 1.5 eVQ
Re-NEET 2024: an I-V curve lying in the fourth quadrant was to be named, and it was the solar cell's.
The LED is the only one used in forward bias; the Zener and the photodiode work in reverse, and the solar cell needs no battery at all.

Common traps

Only full-wave doubles the frequency

A half-wave rectifier gives one pulse per cycle, so its output frequency equals the input frequency, not half of it. A full-wave rectifier gives two pulses per cycle, so twice the input frequency.

Find the half cycle from the period

To say which diode conducts at an instant t, work out T=2π/ωT = 2\pi/\omega first and compare t with T/2T/2. With ω=100π\omega = 100\pi, T is 20 ms, so the negative half runs from 10 ms to 20 ms.

A filter charges to the peak, not the rms

A capacitor on a 220 V (rms) supply charges to about 311 V, the peak value 2×220\sqrt{2} \times 220.

The Zener takes what the load does not

The current in the series resistor splits between the Zener and the load. The Zener current is IS−ILI_S - I_L, not ISI_S.

A change in supply lands on the resistor

When the supply voltage changes, the voltage across the series resistor changes and the load voltage stays at VZV_Z. Only the currents change.

A photodiode works in reverse bias

In forward bias a photodiode carries a large majority current that light hardly changes. In reverse bias the current is tiny, so the extra carriers made by light change it by a large fraction.

Use 1240 with energies in eV

λ in nm is 1240 divided by the energy in eV. Putting an energy in joules into 1240 gives nonsense; with joules, use λ=hc/E\lambda = hc/E.

Logic Gates

Learn this subtopic in the notes

Reducing a circuit with Boolean algebra

De Morgan's theorems

A+B‾=A‾⋅B‾,A⋅B‾=A‾+B‾\overline{A + B} = \overline{A}\cdot\overline{B}, \qquad \overline{A\cdot B} = \overline{A} + \overline{B}

Joined inputs and waveform inputs

Joined inputs

A⋅A‾=A‾,A+A‾=A‾\overline{A\cdot A} = \overline{A}, \qquad \overline{A + A} = \overline{A}

The basic gates and their truth tables

GateOutput YY for inputs 00, 01, 10, 11Y is 1 when
ORA+BA + B0, 1, 1, 1at least one input is 1
ANDA⋅BA\cdot B0, 0, 0, 1both inputs are 1
NOTA‾\overline{A}1 for A = 0, 0 for A = 1the input is 0
NANDA⋅B‾\overline{A\cdot B}1, 1, 1, 0at least one input is 0
NORA+B‾\overline{A + B}1, 0, 0, 0both inputs are 0Q
Re-NEET 2024: an OR gate whose output feeds a NOT gate acts as a NOR gate.
The one row that differs from the other three names each two-input gate.

Common traps

NAND and NOR are easy to swap

NAND is the NOT of AND, so it is 0 only for (1, 1). NOR is the NOT of OR, so it is 1 only for (0, 0). Check the row that differs.

One row fits several gates

An output of 1 for inputs (0, 0) is true of both NAND and NOR. Use a second row, such as (0, 1), to tell them apart.

Break a bar only with De Morgan

A+B‾\overline{A + B} is not A‾+B‾\overline{A} + \overline{B}. When the bar is split, the sign changes too: A+B‾=A‾⋅B‾\overline{A + B} = \overline{A}\cdot\overline{B}.

Invert the right input

A NOT gate on one input changes only that input. Writing A‾\overline{A} where the circuit inverts B gives a mirror-image table, and that table is usually one of the options.

Check one row in the original circuit

After simplifying, put one input pair through the circuit as drawn and compare. A slip in the algebra shows up at once.

Joined inputs make a NOT gate

A NAND or NOR gate with both inputs tied to the same signal inverts it. It does not pass the signal through unchanged.

Cut the time axis at every change

In a waveform question, an interval ends whenever any one input changes, not only when the first input changes. Missing a change merges two rows and gives a wrong output pulse.

More NEET Physics formula sheets