PYQ Vault

NEET Physics · Formula sheet

Electromagnetic Induction formulas

7 formulas, 1 reference table and 21 common traps for NEET Physics Electromagnetic Induction, grouped by subtopic.

Full notes with worked examples

Induced EMF and Lenz's Law

Learn this subtopic in the notes

Magnetic flux and Faraday's law

Flux and Faraday's law

Φ=BAcos⁡θ,ε=−NdΦdt,P=ε2R\Phi = BA\cos\theta, \qquad \varepsilon = -N\frac{d\Phi}{dt}, \qquad P = \frac{\varepsilon^{2}}{R}
  • θ\thetaangle between the field and the normal to the loop
  • NNnumber of turns
  • RRresistance of the closed loop

Motional emf of a moving rod

Motional emf

ε=Blv,I=BlvR,F=B2l2vR\varepsilon = Blv, \qquad I = \frac{Blv}{R}, \qquad F = \frac{B^{2}l^{2}v}{R}
  • lllength of the conductor that cuts the field, perpendicular to v
  • vvspeed of the conductor

Emf of a rotating coil (AC generator)

AC generator

ε=NBAωsin⁡ωt,ε0=NBAω,ω=2πν\varepsilon = NBA\omega\sin\omega t, \qquad \varepsilon_0 = NBA\omega, \qquad \omega = 2\pi\nu
  • ω\omegaangular speed of the coil
  • ν\nurevolutions per second

Lenz's law and eddy currents

SituationWhat the flux doesWhat happens
North pole pushed towards a coilFlux through the coil growsNear face becomes a north pole; the magnet is repelled
North pole pulled away from a coilFlux through the coil fallsNear face becomes a south pole; the magnet is attracted back
South pole pushed towards a coilFlux through the coil growsNear face becomes a south pole; the magnet is repelled
Magnet held at rest near a coilStays the sameNo emf and no current
Conducting sheet moved near a strong magnet poleChanges in parts of the sheetEddy currents oppose the motion, so a force is needed even to move it at steady speedQ
NEET 2024: of four sheets near a strong pole, a force is needed to hold a magnetic one and to move a conducting one at uniform speed.
Non-conducting, non-magnetic sheet near a magnetNo current can flow in itNo eddy currents and no magnetic force
Metal plate swinging between magnet polesChanges as the plate swingsEddy currents damp it quickly; a slotted plate swings much longer
The induced current opposes the change in flux, never the flux itself.

Common traps

The angle is measured from the normal

In Φ=BAcos⁡θ\Phi = BA\cos\theta the angle is between the field and the NORMAL to the loop. A loop whose plane is perpendicular to the field has θ=0\theta = 0 and the full flux BA, not zero.

Emf comes from a change, not from the flux

A large flux that stays constant induces no emf at all. A small flux that changes quickly can induce a large one. The emf is dΦ/dtd\Phi/dt, not Φ\Phi.

Power is never negative

The power in the loop is ε2/R\varepsilon^{2}/R. If the emf varies as cos⁡t\cos t, the power varies as cos⁡2t\cos^{2} t: it falls to zero where the emf is zero and is positive everywhere else.

Opposing the change, not the flux

When the flux is growing, the induced field points against it. When the flux is falling, the induced field points the SAME way as the outside field, to keep it up.

Holding a sheet still is not induction

A magnet attracts an iron sheet, so a force is needed to hold it, but nothing is changing and no current is induced. Induction needs a change of flux, so it acts on a conducting sheet only while it moves.

Eddy currents need a conductor

An insulator carries no eddy currents, so it feels no magnetic braking. Only a conducting body is slowed by its own induced currents.

Using the wrong side of the loop

For a rectangular loop leaving a field, the emf is Blv with l the side that cuts the field lines, the one perpendicular to the velocity. The sides moving along their own length add nothing.

A loop wholly inside the field

Each side of a loop moving inside a uniform field has its own Blv, but the two cancel round the loop. The flux does not change, so no current flows.

Largest emf at zero flux

The emf is largest when the coil's plane lies along the field, where the flux is zero. When the flux is largest, it is momentarily not changing and the emf is zero.

Revolutions per second are not radians per second

Convert a rate in revolutions per second with ω=2πν\omega = 2\pi\nu before using NBAωNBA\omega. Putting ν\nu in place of ω\omega makes the emf 2π2\pi times too small.

Only the field across the axis counts

The part of the field along the axis of rotation never changes the flux. For a coil spun about a vertical axis in the earth's field, only the horizontal component induces an emf.

Self and Mutual Inductance

Learn this subtopic in the notes

Mutual inductance of two coils

Mutual inductance

ε2=−MdI1dt,M=μ0n1n2πr12l\varepsilon_2 = -M\frac{dI_1}{dt}, \qquad M = \mu_0 n_1 n_2 \pi r_1^{2} l
  • n1,n2n_1, n_2turns per unit length of the two solenoids
  • r1r_1radius of the inner solenoid
  • lllength of the solenoids

Self-inductance of a solenoid

ε=−LdIdt,L=μrμ0n2Al\varepsilon = -L\frac{dI}{dt}, \qquad L = \mu_r\mu_0 n^{2}Al
  • nnturns per unit length
  • AAarea of cross-section
  • μr\mu_rrelative permeability of the core (1 for air)

Inductors in a circuit

Inductor in a circuit

VL=LdIdt,Lseries=L1+L2,1Lparallel=1L1+1L2V_L = L\frac{dI}{dt}, \qquad L_{\text{series}} = L_1 + L_2, \qquad \frac{1}{L_{\text{parallel}}} = \frac{1}{L_1} + \frac{1}{L_2}

Energy stored in an inductor

Energy in an inductor

U=12LI2U = \tfrac12 LI^{2}

Common traps

Finding the flux through the wrong loop

For a small loop inside a large one, the large loop's field is easy to find at its centre, but the small loop's field over the large loop is not. Pass the current through the large loop and find the flux through the small one; M is the same either way.

Coaxial solenoids use the inner radius

Only the inner solenoid's cross-section carries flux common to both coils, so M uses πr12\pi r_1^{2} of the inner solenoid, whichever one carries the current.

Turns per unit length, not total turns

In L=μ0n2AlL = \mu_0 n^{2}Al, n is the number of turns per unit length. With the total number of turns N, the formula is μ0N2A/l\mu_0 N^{2}A/l. Mixing the two gives a factor of l2l^{2} wrong.

n is squared

L goes as n2n^{2}, so halving the turns per unit length cuts L to a quarter, not a half. The length and the area enter only to the first power.

L does not depend on the current

A larger current gives a larger flux, but the ratio NΦ/IN\Phi/I stays the same. L changes only with the coil's size, turns or core.

Sign of dI/dt when the current falls

For a falling current, L dI/dtL\,dI/dt is negative, so the potential rises across the inductor in the direction of the current. The inductor then acts with the current, not against it.

An inductor with a steady current

An ideal inductor has no resistance. With a steady current there is no voltage across it at all; it is not a drop of LILI.

Parallel inductors combine like resistors

Inductors (with no mutual inductance) add in series and combine by reciprocals in parallel, the same rules as resistors, not the rules for capacitors.

Energy goes as the square of the current

Half the current stores a quarter of the energy, not a half. Square the current before multiplying by L/2.

Losing the prefix

An inductance in microhenry with a current of a few amperes gives an energy in microjoule. Writing μH as mH makes the answer a thousand times too big.

More NEET Physics formula sheets