PYQ Vault

NEET Physics · Formula sheet

Laws of Motion formulas

7 formulas and 21 common traps for NEET Physics Laws of Motion, grouped by subtopic.

Full notes with worked examples

Newton's Laws and Momentum

Learn this subtopic in the notes

Newton's three laws of motion

Second law

F⃗=Δp⃗Δt=ma⃗,F=F12+F22\vec{F} = \frac{\Delta \vec{p}}{\Delta t} = m\vec{a}, \qquad F = \sqrt{F_1^{2} + F_2^{2}}
  • p⃗\vec{p}momentum, mass times velocity
  • a⃗\vec{a}acceleration, along the net force

Impulse and conservation of momentum

Impulse

J=Favg Δt=Δp=m(v−u),m1u1+m2u2=m1v1+m2v2J = F_{\text{avg}}\,\Delta t = \Delta p = m(v - u), \qquad m_1u_1 + m_2u_2 = m_1v_1 + m_2v_2

Common traps

Force follows the change, not the motion

A body that turns from moving south to moving east, at the same speed, feels a force toward the north-east. That is the direction of Δv⃗=v⃗−u⃗\Delta\vec{v} = \vec{v} - \vec{u}, not of either velocity.

Check which force the angle is measured from

For perpendicular forces F1F_1 and F2F_2, the resultant makes tan⁡−1(F2/F1)\tan^{-1}(F_2/F_1) with F1F_1 but tan⁡−1(F1/F2)\tan^{-1}(F_1/F_2) with F2F_2. The two angles add up to 90°.

Action and reaction never cancel

The two forces of a third-law pair act on different bodies. Only forces on the SAME body can be added to give its net force.

A bounce adds the speeds

When the velocity reverses, the size of the change is m(v+u)m(v + u), not m(v−u)m(v - u). Getting zero for a ball that bounces back to the same height means a sign was dropped.

Turn heights into speeds first

Impulse uses velocities. A drop from h gives 2gh\sqrt{2gh} at the ground; you cannot use the heights themselves in m(v+u)m(v + u).

Impulse is the area, not the peak

On a force-time graph the impulse is the area under the curve. A tall, narrow spike can give less impulse than a low, wide one.

Connected Bodies and Friction

Learn this subtopic in the notes

Connected bodies, tension and contact force

Connected bodies

a=Fm1+m2,N=m2a,apulley=(m1−m2)gm1+m2a = \frac{F}{m_1 + m_2}, \qquad N = m_2 a, \qquad a_{\text{pulley}} = \frac{(m_1 - m_2)g}{m_1 + m_2}

Static and kinetic friction

Friction

fs≤μsN,fk=μkN,amax⁡=μsgf_s \le \mu_s N, \qquad f_k = \mu_k N, \qquad a_{\max} = \mu_s g

Motion on an inclined plane

Inclined plane

adown=g(sin⁡θ−μkcos⁡θ),N=mgcos⁡θ,tan⁡θrepose=μsa_{\text{down}} = g(\sin\theta - \mu_k\cos\theta), \qquad N = mg\cos\theta, \qquad \tan\theta_{\text{repose}} = \mu_s

Common traps

The front block does not get the whole push

A push on the rear block moves both blocks. The block in front receives only its own mass times the shared acceleration, which is less than the applied force.

Only acceleration changes the reading

In a lift moving at constant velocity, up or down, a string holding a body still reads mg. Only an acceleration makes it m(g+a)m(g + a) or m(g−a)m(g - a).

The tension is not the hanging weight

Over a pulley with unequal masses, the tension lies between the two weights: less than m1gm_1g and more than m2gm_2g.

Static friction is only as big as it needs to be

Below the limit, static friction equals the applied force, not μsN\mu_s N. A 2.5 N push on a block whose limit is 10 N meets 2.5 N of friction.

The mass cancels

The largest acceleration before a box on a vehicle's floor slips is μsg\mu_s g. The box's mass does not enter, so a given mass in the question is not needed.

Sliding friction is smaller

Once a body slides, friction drops from the limit μsN\mu_s N to μkN\mu_k N. Use μk\mu_k for anything that is already moving.

Times compare as square roots

From rest over the same length, t∝1/at \propto 1/\sqrt{a}. Taking twice as long means a quarter of the acceleration, not half.

Friction on a slope uses cos θ

On a slope N=mgcos⁡θN = mg\cos\theta, so friction is μmgcos⁡θ\mu mg\cos\theta, not μmg\mu mg.

Going up, both forces slow it

A body moving up a rough slope has gravity's part and friction both pointing down the slope, so the retardation is g(sin⁡θ+μkcos⁡θ)g(\sin\theta + \mu_k\cos\theta), with a plus sign.

Circular Motion

Learn this subtopic in the notes

Centripetal force

Fc=mv2r=mω2r,ω=2πnF_c = \frac{mv^{2}}{r} = m\omega^{2}r, \qquad \omega = 2\pi n
  • ω\omegaangular speed in rad/s
  • nnrevolutions per second

Level and banked roads

Roads

vmax⁡=μsrg,tan⁡θ=vo2rg,vmax⁡=rg μs+tan⁡θ1−μstan⁡θv_{\max} = \sqrt{\mu_s r g}, \qquad \tan\theta = \frac{v_o^{2}}{rg}, \qquad v_{\max} = \sqrt{rg\,\frac{\mu_s + \tan\theta}{1 - \mu_s \tan\theta}}
  • vov_ooptimum speed, needing no friction
  • θ\thetabanking angle

Common traps

Tension goes as ω squared

At a fixed radius T∝ω2T \propto \omega^{2}. Doubling the rotation speed makes the tension four times; four times the tension only doubles the rotation speed.

Centripetal force is not an extra force

Do not draw mv2/rmv^{2}/r as one more force on the body. It is the net of the real forces (tension, friction, normal reaction) toward the centre.

Change rpm to rad/s before using numbers

In T=mω2rT = m\omega^{2}r with actual values, ω\omega must be in rad/s: ω=2π×rpm60\omega = 2\pi \times \dfrac{\text{rpm}}{60}. Only a ratio of two speeds can stay in rpm.

Least tyre wear means no friction

The speed at which tyres wear least is the optimum speed, where the road's normal reaction alone turns the car and no friction is needed. Use tan⁡θ=v2/(rg)\tan\theta = v^{2}/(rg) with no μ\mu in it.

The speed is squared

In tan⁡θ=v2/(rg)\tan\theta = v^{2}/(rg) the speed is squared. Twice the speed needs four times the value of tan⁡θ\tan\theta, not twice.

The level-road limit has no mass in it

vmax⁡=μsrgv_{\max} = \sqrt{\mu_s r g} for a heavy truck and a light car alike. Only the grip and the radius set it.

More NEET Physics formula sheets